GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019 57
System Options Programming
AlarmNet Timers
1. Enter the Installer Code. The control panel will automatically access the Main Menu.
2. Select 7 for Panel Programming.
3. Select 5 for System Options.
4. From the next menu, select 1 for Communication Options.
5. Select 4 for AlarmNet Timers.
6. The available options for AlarmNet Timers are as follows
• Ethernet: *5 minutes, 3 minutes, 90 seconds, 75 seconds, none, 30 days, 24 hours, 1 hour.
• Cellular: *24 hours, none, 30 days
• Old Alarm: *30 minutes, 15 minutes, 10 minutes, none, 24 hours12 hours, 6 hours, 4 hours,2 hours, 1 hour*defaults
• AlarmNet Timers
Figure 7.9 AlarmNet Timers
Phone Line Gains
1. Enter the Installer Code. The panel will automatically access the Main Menu.
2. Select 7 for Panel Programming.
3. Select 5 for System Options.
4. From the next menu, select 1 for Communication Options.
5. Select 5 for Phone Line Gains
6. The available options:
• Dialing: Low, *High (default), Normal
• Reporting: *Low (default), High, Normal
Figure 7.10 Phone Line Gains
Daytime/Nighttime Sensitivity
If you need to change the time that sensitivity levels take effect (that is, the time that “Day” and “Night” begin), follow these steps.
1. Enter the Installer Code.
2. Select 7 for Program Menu.
3. Select 5 for System Options.
4. From the System Options Menu, select 2 for Day/Night Sense.
A screen similar to the one shown in Figure 7.11 will display
.
Figure 7.11 Changing Day/Night Sensitivity Time
To Next Page
Loading...
