GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2013 Honeywell International Inc. All rights reserved.
www.gamewell-fci.com CS-2045 Rev. C page 1 of 2
RCE-95
Relay Control Element
APPROVED
MEA
Approved
7300-1703:0135
SIGNALING
S521
FM
Description
The Gamewell-FCI Relay Control Element (RCE-95) is the
interface between the Gamewell-FCI, 600 Series and
IL95-E3 Series
®
Fire Alarm Control Panel (FACP) analog
circuits and building functions such as door holders, eleva-
tors, dampers, motors and disconnects. The RCE-95
offers feedback input points for positive confirmation of the
controlled device’s activity. For annunciation and feedback
at the panel, Gamewell-FCI offers a Relay Control Display
(RCD). The RCD is only available with the IdentiFlex 632
and IF650 FACPs.
The RCE-95 can be either surface or flush mounted and
has an integral LED which annunciates upon device
activation.
Operation
The devices connect to the SLC circuit of the FACP via a
two-wire non- polarized circuit. In its quiescent mode, the
RCE-95 monitors its internal circuitry for status of the
device itself and supervises an external control circuit for
status.
When a status change is detected, the event can be pro-
grammed to display on the optional RCD module (IF632
and IF650 only). When an event is reported to the control
panel that requires the activation of the RCE-95, the con-
trol panel communicates via the analog circuit to the RCE-
95 for activation. The integral LED is also lit for annuncia-
tion at the device.
Programming
The RCE-95 is programmed by setting a single DIP switch
easily accessible on the RCE-95’s printed circuit board.
The DIP switch is used to set the address of the device. All
other programming is accomplished at the Fire Alarm Con-
trol Panel, either through a laptop computer or the control
panel operator’s display. (600 Series only).
E3 Series® is a registered trademark of Honeywell International Inc.
Microsoft® Windows® is a registered trademark of Microsoft® Corporation.
Features
• Compatible with the Gamewell-FCI, 600 Series and
ILI95-E3 Series analog addressable FACPs
• Supports Form-C dry relay contacts
• Offers event or manual controllable relay functions
• Provides positive feedback of relay activation
• Contains LED annunciates activation
• Is fully supervised
• Has surface or flush mounting
• Field programmable
• Style 4, 6, or 7 wiring
• Includes Screw terminals for field wiring connections
RCE-95
To Next Page
Loading...
