Honeywell GENT Vigilon Plus Series - Panel Labels and Map Viewing

31
Vigilon Plus fire alarm system
How to view the local panel label
When there is a network of control panels and nodes
connected together in a system then each panel/node
is usually given an identication label, also referred to
as the Local panel label.
a. Press the MENU ON/OFF button.
b. Press the F3 button to select [Info]. Ignore
step c. if an integral printer is not tted or is
switched off.
c. To display a local panel label press the F1 button
to select [Display] or to print a local panel label
press the F2 button to select [Print]. Notice
‘Display’ or ‘Print’ appears on the screen.
d. Press the F4 button to select <etc>.
e. Press the F2 button to select [Label]. Notice
‘Label’ appears on the display.
f. Press the F4 button once to select <etc>.
g. Press the F2 button to select [Local]. Notice
‘Local’ appears on the display.
h. Press the F2 button to select [Enter]. Notice the
selected label information is either displayed or
printed.
To view or print a map
NA
The [Loop map] option is not applicable for Vigilon Plus
Network Node.
A map provides information on devices that are connected to a loop
off a control panel in a re alarm network.
a. Press the MENU ON/OFF button.
b. Press the F3 button to select [Info]. Ignore step c. if an integral
printer is not tted or is switched off.
c. To display a loop map press the F1 button to select [Display] or
to print a loop map press the F2 button to select [Print]. Notice
‘Display’ or ‘Print’ appears on the screen.
d. Press the F4 button to select <etc>.
e. Press the F4 button to select [UserCode]. Notice a message on
the display ‘Enter access code’, followed by a ashing cursor.
Use the keypad to input your PIN and then press Enter button.
f. Press the F3 button to select [Loop Map] or [Map].
g. On selecting [Map] you have a choice of either [Loop Map] or
[Net Map].
h. On selecting [Loop Map] notice ‘Loop Map’ followed by a
ashing cursor appear on the display.
i. On selecting [Net Map] notice ‘Node’ followed by a ashing
cursor appear on the display.
j. Use the keypad to enter the loop number or node number and
then press F3 to select [Enter]. Notice the map is either printed
or displayed.
www.acornfiresecurity.com
www.acornfiresecurity.com