Honeywell GENT Xenex - System Operation Procedures

Normal indications Fire Panels
5 4188-424 issue 8_Part 2_07-14_Xenex
Operating instructions
Normal indications
Under normal condition the panel should give a healthy indication, with only the green Power light lit.
The control panel provides system security by password entry to controls.
Fire Condition
In the event of an automatic fire detection the indications given are:
q FIRE light is lit.
q Zones-fire light is lit.
q buzzer sounds continuous tone.
q system alarm sounders are activated
q if applicable, auxiliary equipment is actuated
q if applicable, automatic link to the Fire Brigade is initiated.
After the emergency is over
After the emergency is over silence the alarms and reset the system:
a)
Enter the 3 digit code to gain access to the controls.
b)
Press the Silence Alarms button. Notice the system alarm sounders are silenced and local buzzer
sounds a continuous tone.
c) After the cause of the alarm has been investigated, ensure smoke and excess heat have had time to clear
from automatic detectors and broken manual call point glasses have been replaced where necessary and
manual call point resettable element is reset. Press the System Reset button. Notice the indications
return to their pre fire status.
To Sound Alarms or Resound Alarms
To re-sound the alarm sounders during a fire condition:
a)
Enter the 3 digit code to gain access to the controls.
b)
Press the Sound Alarms button. Notice the system alarm Sounders are activated.
To Silence Alarms
To silence system the alarm sounders after they have been activated:
a)
Enter the 3 digit code to gain access to the controls.
b)
Press the Silence Alarms button. Notice the system alarm Sounders are silenced.
n
n
n
n
n
n
n
n
n