Honeywell Granit 1980i - Page 298

278 Xenon/Granit User Guide
Character Activation Mode *Off HSTCEN0 127
On HSTCEN1 127
Activation Character (Range 0-
255) *12 [DC2]
HSTACH### 128
Do Not End Character Activation
After Good Read
HSTCGD0 128
End Character Activation After
Good Read
HSTCGD1 128
Character Activation Timeout
(Range 1 - 300,000) *30,000 ms
HSTCDT###### 129
Character Deactivation Mode *Off HSTDEN0 129
On HSTDEN1 129
Deactivation Character (Range 0-
255) *14 [DC4]
HSTDCH### 129
Illumination Lights *Lights On SCNLED1 130
Lights Off SCNLED0 130
Aimer Delay 200 milliseconds SCNDLY200 130
400 milliseconds SCNDLY400 130
*Off (no delay) SCNDLY0 130
User-Specified Aimer Delay Range 0 - 4,000 ms SCNDLY#### 131
Aimer Mode (not supported by
Granit 1980i and 1981i)
Off SCNAIM0 131
*Interlaced SCNAIM2 131
Single Code Centering Single Code Centering DECWIN1;DECTOP49;DECBOT
51;DECRGT51;DECLFT49
132
Centering Window Centering On DECWIN1 133
*Centering Off DECWIN0 133
Left of Centering Window (*40%) DECLFT### 134
Right of Centering Window (*60%) DECRGT### 134
Top of Centering Window (*40%) DECTOP### 134
Bottom of Centering Window
(*60%)
DECBOT### 134
Preferred Symbology On PRFENA1 134
*Off PRFENA0 135
High Priority Symbology PRFCOD## 135
Low Priority Symbology PRFBLK## 135
Preferred Symbology Timeout
(*500) Range 100-3000
PRFPTO#### 135
Preferred Symbology Default PRFDFT 136
Output Sequence Editor Enter Sequence SEQBLK 138
Default Sequence SEQDFT 138
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page