Honeywell Granit XP 1990iSR - Replacing Interface Cables and Batteries; Troubleshooting Corded Scanner Issues

Granit XP User Guide 257
QR Code Append *One Scan QRCAPP1 188
Swipe QRCAPP2 188
Point & Shoot QRCAPP3 188
Off QRCAPP0 188
QR Code Page QR Code Page (*3) QRCDCP## 189
DotCode Default All DotCode Settings DOTDFT 190
On DOTENA1 190
*Off DOTENA0 190
Poor Quality DotCodes Poor Quality DotCodes On DOTEXS1 190
*Poor Quality DotCodes Off DOTEXS0 190
DotCode Msg. Length Minimum (1- 2400) *1 DOTMIN#### 190
Maximum (1- 2400) *2400 DOTMAX#### 190
Digimarc Barcode Decoder Attempts (0-10) *3 DIGSTR## 191
Off DIGENA0 191
On DIGENA1 191
Uses ID Decoder then Both
Decoders
DIGENA2 191
*Uses Digimarc Decoder then
Both Decoders
DIGENA3 191
Uses ID Decoder then Alternates
Decoders
DIGENA4 191
Uses Digimarc Decoder then
Alternates Decoders
DIGENA5 191
Data Matrix Default All Data Matrix Settings IDMDFT 191
*On IDMENA1 191
Off IDMENA0 191
Direct Part Marking (DPM)
Decoding
Dotpeen DPM Decoding DPMENA1 192
*Disable DPM Decoding DPMENA0 192
Reflective (Etched) DPM
Decoding
DPMENA2 192
Data Matrix Msg. Length Minimum (1-3116) *1 IDMMIN#### 193
Maximum (1-3116) *3116 IDMMAX#### 193
Data Matrix Code Page Data Matrix Code Page (*51) IDMDCP## 193
MaxiCode Default All MaxiCode Settings MAXDFT 194
On MAXENA1 194
*Off MAXENA0 194
MaxiCode Msg. Length Minimum (1-150) *1 MAXMIN### 194
Maximum (1-150) *150 MAXMAX### 194
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page