Honeywell Granit XP 1990iSR - Partial Sequence Handling

Granit XP User Guide 57
If there are no trigger pulls during the timer interval, the scanner goes into power
down mode. Whenever the trigger is enabled, the timer is reset. The scanner will not
go into power down mode when it is in the base and charging. Default = 3600 sec-
onds.
Note: When the scanner is in power down mode, press the trigger to power the unit back up.
There will be a set of power up beeps and a delay of up to a few seconds for the radio
to join. The scanner will then be ready to use.
0 seconds
200 seconds
400 seconds
900 seconds
* 3600 seconds
7200 seconds