Granit XP User Guide 49
About the Bluetooth Status Icon
The blue Bluetooth Icon LED has two behaviors flash and on. The icon will flash
when linking to a device then will remain on, indicating the base and scanner are
linked and stays on when the scanner is in base.
Once the scanner is removed from base, the blue LED stays on for four seconds
then turns off.
Note: Link status can be checked by holding the trigger for three seconds, the BT LED will
stay on for four seconds when BT is linked.
About the Battery Status Icon
The Battery status icon displays the charged level of the battery. Low-power alerts
are non-configurable. See the table below to learn more about low power
indicators.
Reset Scanner
Scanning this barcode reboots the scanner and causes it to relink with the base or
Access Point.
Base Charge Modes
When the base has both an external power supply (plugged into the auxiliary power
port) and a host interface cable, it will draw its power from the external power sup-
ply. When the base does not have an external power supply, it draws its power from
the interface cable. However, the scanner charges more slowly from a host inter-
face cable than if auxiliary power were available. Using the following selections,
you can specify whether the scanner is charged from power supplied via the host
interface cable.
When Base Charge Off is selected, the scanner does not charge when the scanner
is in the base cradle.
Scanner LED Scanner Beep Charge Level
Yellow 3 sets of flashes No beep <15%
Red 3 sets of flashes, repeatedly
every 3 seconds
No Beep <5%
Red 20 sets of rapid flashes No Beep <2%
To Next Page
Loading...
