Granit XP User Guide 51
Page Pitch
When you press the page button on the base or Access Point, the scanners associ-
ated with that base or Access Point will begin beeping (see Page Button on page
43). You can set the pitch of the paging beep for each scanner by scanning one of
the following barcodes. Default = Low.
Error Indicators
Beeper Pitch - Base Error
The base can be configured to beep at a particular pitch when an error occurs,
such as transmission problems to a host system. The beeper pitch codes modify
the pitch (frequency) of the error tone the base emits when there is an error. Default
= Low.
To Next Page
Loading...
