Honeywell GSMV4G - ECP Status Codes

Section 3: Programming the Communicator
3-7
PROMPTS
OPTIONS
DESCRIPTION
30
Enable Zn6 Y/N
(N)_
[Y], [N]
Enables alarm reporting for zone 6.
If [N], skip to Prompt 35: "Enable Zn7."
31
Zn6 Trigger Type
(V+)_
•
(V+)
• (V–)
•
(EOLR)
Selects the triggering method for this zone input.
Press the [space] key to scroll through choices.
32
Invert Zn6 Y/N
(N)_
[Y], [N]
Inverts the alarm and normal states of the zone 6 trigger; otherwise
uses normal input signal.
33
Restore Zn6 Y/N
(Y)_
[Y], [N]
Enables restore reporting for zone 6.
UL/ULC: Must be set to “Y.”
34
Delay Zn6 (secs)
(00)_
[01-15]
[00] = no delay
Defines the reporting delay in seconds for zone 6.
UL/ULC: Must be set to “00.”
35
Enable Zn7 Y/N
(N)_
[Y], [N]
Enables alarm reporting for zone 7.
If [N], skip to Prompt 40: "Review."
36
Zn7 Trigger Type
(V+)_
•
(V+)
• (V–)
•
(EOLR)
Selects the triggering method for this zone input.
Press the [space] key to scroll through choices.
37
Invert Zn7 Y/N
(N)_
[Y], [N]
Inverts the alarm and normal states of the zone 7 trigger; otherwise
uses normal input signal.
38
Restore Zn7 Y/N
(Y)_
[Y], [N]
Enables restore reporting for zone 7.
UL/ULC: Must be set to “Y.”
39
Delay Zn7 (secs)
(00)_
[01-15]
[00] = no delay
Defines the reporting delay in seconds for zone 7.
UL/ULC: Must be set to “00.”
40
Review? Y/N
[Y] = review
[N] = exit
Reviewing Programming Mode Entries
To review the programming options, press [Y]. The programming
prompts are displayed again. Use the up/down arrow keys to scroll
through the program fields without changing any of the values. If a
value requires change, simply type in the correct value. When the
last field is displayed, the “REVIEW?” prompt again appears.
To exit the programming mode, press [N] in response to the
"REVIEW?" prompt, and refer to Exiting Programming Mode
paragraph at the end of this section.
ECP Status Codes
When the communicator is configured for ECP mode, it sends status messages to the control
panels for battery, power, tamper, and network connectivity failures. Some of the control
panels, (e.g., VISTA-10P, VISTA-15P and VISTA-20P Series) display these on the keypad as
“LngRng Radio” followed by a 4-digit code (listed below). In addition, the Contact ID codes
(listed in Appendix B) for these conditions are sent to the central station by the
communicator.
UL
The information in the following table is based on the VISTA-20 which has not been evaluated
with this communicator.
Table 3-3. Common ECP Keypad Display Status Codes
STATUS CODE
DESCRIPTION
0000
Control panel lost communication with communicator.
0880
Communicator tamper detected (cover removed).
0005
Communicator has lost contact with AlarmNet-G network.
000F
Communicator is not registered; account not activated.