EasyManua.ls Logo

Honeywell GSMV4G - Appendix B: Central Station Messages; ECP Mode Messages; Zone and 4204 Modes Messages; Specific to Residential; Commercial Control Panels

Honeywell GSMV4G
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendices
B-1
Appendix B: Central Station Messages
Alarm Condition
ECP Mode
Zone and 4204 Modes
Alarm Code
Restore Code
Alarm Code
Restore Code
Power On / Reset E339 C08xx* 5551 5555 6
Tamper
(Compromise Indication)
E341 C08xx* R341 C08xx* 5555 5551 7 5555 5553 7
Power Loss E337 C08xx* R337 C08xx* 1555 5555 6 3555 5555 6
Low Battery E338 C08xx* R338 C08xx* 5155 5555 6 5355 5555 6
Battery Charger Failure E314 C08xx* R314 C08xx* 5155 5555 1 5355 5555 1
ECP Supervision
(Compromise Indication)
E355 C0000 R355 C0000 5555 5515 5 5555 5535 5
Communication Path Supervision R350 C0951 5555 5553 5
Telco
(Compromise Indication)
5555 5155 6 5555 5355 6
Open/Close
2 sent in selected
zone
4 sent in selected
zone
Test 5555 5555 9 5555 5555 9
Specific to RESIDENTIAL / COMMERCIAL Control Panels (Such as the VISTA-10P, 15P, and 20P series.)
UL
The information provided in this section for the VISTA-10P, 15P, and 20P series control panels
has not been evaluated with this communicator.
Communicator Trouble (low battery,
ECP bus, network)
(Possible Compromise Indication)
E353 C08xx* R353 C08xx*
Radio Fault
E353 0 1xx* R353 0 1xx*
Specific to COMMERCIAL Control Panels (Such as the VISTA-128/250 series.)
Communicator Trouble (low battery,
ECP bus, network)
(Possible Compromise Indication)
E333 C08xx* R333 C08xx*
Radio Loss of Signal
(Possible Compromise Indication)
E357 0 8xx*
R357 0 8xx* or
R380 0 8xx*
Radio Fault (low battery, tamper,
ECP Bus)
E333 0 8xx* R333 0 8xx*
AlarmNet Messages
Communication failure.
(Possible Compromise Indication)
5555 1555 6 5555 3555 6
Authorized Radio Substitution 00D0 010C 0
Unauthorized Radio Substitution
Attempt
00D0 010E 0
Service Termination 00D0 020E 0
* xx = Communicator Device Address
† = Message is sent by dialer only.
‡ = Message is sent by dialer and radio.
◊ = Message is sent by dialer only, or dialer and radio, depending on failure.

Table of Contents

Other manuals for Honeywell GSMV4G

Related product manuals