GSMX Installation and Setup Guide
ā 13 ā
Programming Options
NOTE: The default programming values are listed in the prompts below.
PROMPTS ENTRY OPTIONS DESCRIPTION
1
Strt Prog
Mode?
(Y/N)_
[Y], [N] Enters programming mode.
2
Enter
Password
[0-9, A-F,
N, S, T, X,
Y]
If a password has been previously
assigned, this prompt appears.
Enter a 4-digit password
(0-9, A-F, N, S, T, X, Y).
The next prompt appears.
3
Program
Device?
(Y/N)_
[Y], [N] To begin programming the
module, press [Y] and go to
Prompt 9: "Device Mode."
To create a password if none has
been assigned, press [N] and go to
Prompt 4: "Create Password?."
To change an existing password,
press [N] and go to Prompt 5:
"Change Password?."
4
Create
Password?
(Y/N)_
[Y], [N] Passwords can be used to protect
account and programming
information.
If no password has been assigned,
this prompt appears after
pressing [N] at the "Program
Device?" prompt.
If a password is desired, press [Y]
and go to Prompt 6: "Enter
Password."
To Next Page
Loading...
