Setup
______________________________________________________________________________________________
48
Setting Up Motion Detection Recording
To record data only when motion is detected:
1. Press SETUP on the front of the DVR or remote control.
2. Select Record > Motion/Event Configuration and set MOTION to
ON.
3. Set the motion SENSITIVITY level. [1~10].
4. Select AREA and press ENTER to set a motion area (global setting;
each channel can be configured individually).
5. Use the mouse to select or clear squares on the grid:
a) Right click and select CHANNEL SELECT.
b) Click the squares to include in the motion grid.
c) Right-click again and select SAVE to save the selected motion
grid.
6. When finished selecting motion areas press ENTER on the front of
the DVR or remote control to save changes.
7. Repeat as necessary for each channel.
8. When motion area setup is complete select SAVE to save settings
and exit setup.
To Next Page
Loading...
