Performance Series DVR User Guide
______________________________________________________________________________________________
Document 800-06801 Rev B 51
06/10
Alarm Monitor
Send event information to a remote client using the Alarm Monitor software.
1. Select SEND TO ALARM MONITOR and press ENTER to select ON.
2. Select the types of events to send to the Emergency Agent
(MOTION, SENSOR, MOTION + SENSOR.)
3. Enter the IP ADDRESS of the remote client.
4. Enter the PORT number.
Note The port number selected is the port that Alarm Monitor uses on
the remote PC. The port shown in this screen must match the port
shown in Alarm Monitor or HFVMS and the port must be open on
the remote PC.
To Next Page
Loading...
