Remote Software
______________________________________________________________________________________________
74
Remote Software
Set up a Remote Connection
The administrator and up to nineteen additional users (four simultaneously)
can access the DVR remotely using software installed on a personal
computer.
Configuring the DVR
1. Press the SETUP key on the front of the DVR or remote control to log in.
2. Select NETWORK > NETWORK CONFIGURATION (see the Network
Configuration section of this manual for more details).
3. Change port settings or write down current port settings.
4. Select DHCP or STATIC IP depending on your network (Ask your
network administrator for assistance).
5. If STATIC IP is selected - define the IP address and additional network
information.
6. If DHCP is selected - write down the IP address supplied by the DVR
system.
Note If the DVR does not display the IP Address after setting DHCP to
ON, Select Save to change the network and open Network
Configuration again.
7. Select SAVE to save current settings.
To Next Page
Loading...
