Honeywell H.264 HRDP - Creating a DVR Connection with Remote Software; Default Remote Software Log in Information

Performance Series DVR User Guide
______________________________________________________________________________________________
Document 800-06801 Rev B 75
06/10
Creating a DVR Connection with Remote Software
1. Install the Remote Software on a PC using the disc provided with your
DVR.
2. Open the Remote Software. The Local Setup window will open
automatically.
3. Click New.
4. Select HRDP H264 as the Site Type.
5. Enter a name for the system in the Site Name box.
6. Enter the IP address of the DVR - found in NETWORK > NETWORK
CONFIGURATION on the DVR.
7. Enter the Port number found in NETWORK > NETWORK
CONFIGURATION on the DVR (default is 4000).
8. Click OK.
9. Enter the user name and password of an authorized user as defined in
SYSTEM > USER CONFIGURATION on the DVR.
Note User Name and Password are both case sensitive.
10. Click Connect.
Default Remote Software Log in Information
The default administrative log in information for the remote software:
User Name: admin
Password: <none>