www.honeywell.com/security
120 | HDZ Series IP PTZ User Manual
Enabling PPPoE
If you connect to the network using PPPoE (Point-to-Point Protocol over Ethernet), you can
enable PPPoE support. To enable PPPoE support:
1. Navigate to System
Network Basic (see Figure 7-8).
2. Select the Use PPPoE option in the General section of the screen.
3. Enter your PPPoE User name and Password, and then click Save.
Configuring Ports
You can change the settings of the ports listed in Table 7-2.
1. Navigate to System
Network Basic (see Figure 7-8).
2. Under Advanced, enter a new port value in the field corresponding to the port you want to
change, and then click Save.
Enabling IPv6 Address Configuration
If you are using a routed IPv6 (Internet Protocol version 6) network, you can enable IPv6 address
configuration. To enable IPv6 address configuration:
1. Navigate to System
Network Basic (see Figure 7-8).
2. Under IPv6 Address Configuration, select the Enable IPv6 check box and click Save.
QoS (Quality of Service)
Note Your network routers and switches must support QoS for these settings to apply.
Table 7-2 Ports that Can be Individually Configured
Port Description
Web Server (HTTP) The default setting of the web server port is 80. Make sure to notify users of any change to
this setting. For example, if you change the port of a camera whose IP address is
192.168.0.100 from 80 to 8080, users will need to type http://192.168.0.100:8080
into the address bar of their web browser for the connection to be successful.
RTSP The default setting of the RTSP port is 554. The setting range is from 1024 to 65535.
MJPEG over HTTP The default setting of the MJPEG over HTTP port is 8008. The setting range is from 1024 to
65535.
HTTPS The default setting of the HTTPS port is 443. The setting range is from 1024 to 65535.
Note This setting cannot be the same as the web server port.
To Next Page
Loading...