Configuring System Settings | 129
800-11873V4 - A - 07/2014
Note To use these schedules with camera features such as network failure and/or
motion detection, By schedule must be selected for each of those features when
you are configuring them.
Deleting a Scheduled Time Frame
1. Navigate to System Schedule (see Figure 7-16).
2. Select one of the schedule time frames in the schedule window and click Delete.
Storage Settings
Storage management settings are split between SD card and Network attached storage device
settings. Go to the section corresponding to your selected storage type for more information.
SD Card Storage Management
You can record up to 32 GB of data on a microSDHC card. A microSDHC card of any size
between 8 and 32 GB can be installed into the microSDHC card slot on the back plate of the
camera (
see
Figure 2-5
and
Table 2-3
on
page 29
for the location of the microSDHC card slot)
.
It is a good practice to format your microSDHC card before using it for the first time.
Checking the Free Space Remaining on the MicroSDHC Card
1. A microSDHC card must be installed into the slot on the back of the camera (
see
Figure 2-5
and
Table 2-3
on
page 29
).
2. Navigate to System
Storage Management SD Card (see Figure 7-17).
The amount of free space on the card is listed under Device information.
Formatting the MicroSDHC Card
1. Navigate to System Storage Management SD Card (see Figure 7-17).
Note Before formatting your microSDHC card, be sure to stop all current recordings
that your camera may be performing (check and stop scheduled recording, and
alarm, motion and network failure recordings that are set).
2. Click Format in the Device setting area of the SD Card screen.
To Next Page
Loading...