www.honeywell.com/security
84 | HDZ Series IP PTZ User Manual
Enabling/Disabling Auto Calibration
1. Navigate to PTZ Camera.
2. Under Misc (see Figure 5-14), in the Auto calibration drop-down list, select one of the
following:
• On to enable auto calibration.
• Off (default) to disable auto calibration.
3. Click Set to save the setting.
2D Noise Reduction
2-dimensional noise reduction (2DNR) reduces image noise produced in low-light conditions.
2D noise reduction technology reduces noise by maintaining smooth edges on moving objects.
Enabling/Disabling 2D Noise Reduction
1. Navigate to PTZ Camera.
2. Under Misc (see Figure 5-14), in the 2DNR drop-down list, select one of the following:
• On to enable noise reduction.
• Off (default) to disable noise reduction.
3. Click Set to save the setting.
3D Noise Reduction
3-dimensional noise reduction (3DNR) reduces image noise produced in low-light conditions.
3D noise reduction technology reduces noise by maintaining smooth edges on moving objects.
Note 3D Noise Reduction is only available for HDZ30(X) and HDZ36E(X) PTZ models.
Enabling/Disabling 3D Noise Reduction
1. Navigate to PTZ Camera.
2. Under Misc (see Figure 5-14), in the 3DNR drop-down list, select one of the following:
• On to enable noise reduction.
• Off (default) to disable noise reduction.
3. Click Set to save the setting.
Stabilizer
The stabilizer option will use software adjustments to stabilize a vibrating image when the PTZ
camera is installed in high wind, or other high-vibration environments.
To Next Page
Loading...