Web Operation | 207
800-18160 - A - 06/2014
Configuring Pan/Tilt/Zoom Settings
Before Configuring PTZ Settings
Please ensure that the following connections are correct before configuring the PTZ settings.
• Ensure that the PTZ and decoder connections are correct, and that the decoder address
setup is correct. See Configuring PTZ Settings on page 107.
• Ensure that the Decoder A line connects to the NVR A line, and that the B lines are also
connected correctly.
Click Pan/Tilt/Zoom in the General settings configuration interface to open the Pan/Tilt/Zoom
settings configuration interface.
Figure 5-71 Pan/Tilt/Zoom Local Configurations Interface
Figure 5-72 Pan/Tilt/Zoom Remote Configurations Interface
Table 5-28 PTZ Configurations
Configuration Description
Channel Select a channel for the PTZ dome camera.
PTZ Type Select from Local or Remote, if you are connecting to the
network PTZ.
Protocol Select a PTZ dome camera protocol, such as PELCOD.
To Next Page
Loading...