14 10260A Series Actuators – Installation, Operations, and Maintenance 2/03
5.500 [139.70]
9.812 [249.22]
8.938 [227.03]
4.469 [113.51]
1.625 [41.28]
DIA
3.375 [85.73]
11.125 [282.58] MIN FOR COVER REMOVEL
FULL CRANK
TRAVEL 90°
1/2-20UNF-2B X 1.239(31.47)
DEEP THREAD
1/2-13UNC-2B X 2 LONG
GRADE 5 OR BETTER BOLT
4.500
1.938
(49.21)
(114.3)
TAPPED HOLE FOR
1" CONDUIT.
ACCESS COVER TO
TERMINAL BOARD
2.500
(63.50)
ACCESS COVER
4.000
4.718
5/16-24 UNF-2Bx.500 (12.7) DP.
TYP. 4 TAPPED HOLES EACH SIDE
1.000 DIA. (25.4)
SHAFT
0.688
(17.46)
HANDWHEEL
MOTOR
(REF.)
(REF.)
7.688
3.844
(195.26)
(97.63)
MOTOR
.281(7.14) DIA.HOLE(4)
ACCESS COVER TO
SPUR GEARING
(121.43)
(101.6)
HANDWHEEL
10269 SERIES HAS A
KNURLED OUTPUT SHAFT
SPACER
0.437 [11.10]
0.375
0.596 [15.15]
2.718 [69.04]
1.375 [34.93]
2.125 [53.98]
5.375 [136.53]
2.031 [51.59]
0.437 [11.10]
0.596 [15.15]
5.000
2.125
8.625
8.187 [207.95]
10.125 [257.18]
1.500 [38.10]
0.687 [17.45]
11.062 [280.97]
[127.00]
MAX
53.98
[219.08]
[9.52]
NOTES:
1. ACTUATOR CAN BE MOUNTED IN ANY POSITION.
2. PROVIDE ADEQUATE CLEARANCE AT ALL ACCESS COVERS
FOR
SERVICING AND ADJUSTMENTS.
3. WIRING DIAGRAM IS LOCATED ON THE INSIDE OF THE
CRANK ARM (GOLD) CONFIGURATION
TO MATCH CAST IRON (SILVER) CRANK ARM
ROD END CENTERLINE. USE KIT 51309755-501
Figure 3-1 Outline and Dimensions of 10261A, -62A, -64A, -66A, -67A, -68A, and -69A Actuators
To Next Page
Loading...
