Honeywell HercuLine 10260A - Power Connections; CE Wiring; 0;4-20 Ma, 0;1-5 VDC Input Signal Connections; 0;4-20 Ma, 0;1-5 VDC Feedback Signal Connections

10260A Series Actuators Installation, Operations, and Maintenance Manual
24 10260A Series Actuators – Installation, Operations, and Maintenance 2/03
3.4.3 Power Connections
For connections, refer to section 3.4.2. Customer Connections.
3.4.4 CE Wiring
For CE approved units clamp the ferrite filter provided (087414) around the AC mains power supply wires
(hot, neutral, ground) inside the case near the conduit entry.
3.4.5 0/4-20 mA, 0/1-5 Vdc Input Signal Connections
For connections, refer to section 3.4.2. Customer Connections.
ATTENTION
Shielded and grounded cables are recommended.
3.4.6 0/4-20 mA, 0/1-5 Vdc Feedback Signal Connections
For connections, refer to section 3.4.2. Customer Connections.
ATTENTION
Shielded and grounded cables are recommended.