Honeywell HERMetic UTImeter Gtex Chem IIC - Selecting the Temperature Resolution

50489/GTEX Chem IIC/1805 UTImeter Gtex Chem IIC
31
5.2 Selecting the temperature resolution
The temperature reading can be given with 1 or 2 digits after the dot. Select the appropriate resolution as
shown on Figure 9-4.
Figure 9-4
- Switch on the equipment,
- Wait until the temperature is displayed,
- Press on "+" to enter the settings menu,
- Press on "enter", "LED menu" is displayed,
- Press on "+"; "T. unit" is displayed,
- Press on "+", "Resol." is displayed,
- Press on "enter",
- Select the resolution by pressing on "+" one or more times, the pointer shows the resolution selected,
- Press "-" two times to come back in measurement mode.
The new setting is stored in the permanent memory.
ON
UTImeter
Battery
Init.
********
*
25.94
°
C
Settings
T. unit
Resol.
>0.0
°
> 0.00
°
Ver x.xx
LED menu



97%
E
E
-
-
-
+
+
+
+
+
+
-