50489/GTEX Chem IIC/1805 7 UTImeter Gtex Chem IIC
3.5. Certification
The equipment has been approved for the
electrical intrinsic safety by the following
authorities :
IECEx
Ex ia IIC T4 Ga / -20°C < Ta < +50°C
/ -40°C ≤ Tp ≤ +90°C
Standards used:
IEC 60079-0:2011
IEC 60079-11:2011
ATEX
II 1 G Ex ia IIC T4 Ga / -20°C ≤ Ta ≤ +50°C
/ -40°C ≤ Tp ≤ +90°C
Standards used:
EN60079-0:2012 + A11
EN60079-11:2012
Regarding product compliance against standards
updates or new standards, please refer to the
Declaration of conformity.
The equipment has been approved as oil/water
interface detector according to MARPOL
Resolution MEPC.5(XIII) of 13 June 1980 by
National Maritime Authorities and/or Classification
Societies.
If you need a copy of any of these certificates
please contact:
Enraf Tanksystem SA
Rue de l'industrie 2
1630 Bulle, SWITZERLAND
Telephone : +41-26-91 91 500
Telefax : +41-26-91 91 505
Web site : www.tanksystem.com
E-mail : tanksystem@honeywell.com
3.6. Spare parts
When ordering spares identify the spare part by
TS number and description. Refer to section
“Drawings”.
Some spares might be repairable; in this case
send the part(s) to any authorised service center
or to the factory.
In case of urgency, complete replacement units
can be made available. Contact the factory or
nearest Service Station for details.
3.7. Service and Repair
The customer is responsible for any freight and
customs clearance charges. If units are sent on a
"freight collect" the charges will be invoiced to the
customer.
When returning units or parts for repair to the
factory please fill out a service request form (see
next page). The serial number (letter "G" followed
by 5 digits) is printed on the identification plate as
shown on the Figure 7-1.
When returned to Enraf Tanksystem SA
equipment must be contamination-free. If it is
determined that the customers equipment is
contaminated, it will be returned to the
customer at the customers expense.
Contaminated equipment will not be repaired
until such time that the customer
decontaminates the said equipment.
Enraf Tanksystem SA is an
ISO 9001 certified
company by Intertek and
MED-D by Det Norske
Veritas Certification
GmbH.
To Next Page
Loading...
