EasyManuals Logo

Honeywell HPA060 Series Important Safety Instructions

Honeywell HPA060 Series
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
HOW YOUR AIR PURIFIER WORKS
This model air purifier incorporates a 2-stage cleaning
system to help clean the air that passes through the filter
in the unit (Fig. 1).
Stage 1: Household Gas & Odour Reducing Pre-Filter
Stage 2: True HEPA Filter that captures particles
as small as 0.3 microns or larger
2
Filter(s)
Odour Reducing
Pre-Filter
STAGE 1
STAGE 2
Fig. 1
• Selectafirm,levelandflatlocation.Forbestairflow,locatetheunitsoitisnotdirectlyupagainstthe
wall or against any furniture. This will enhance performance.
• Whenoperating,largevolumesofairaredrawntowardtheairpurifier.Surroundingareasshouldbe
cleaned and/or vacuumed frequently to prevent build-up of dust and other contaminates. This may
also help prolong the life of the filter. If the unit is placed on a light coloured carpet, a small mat or rug
should be used underneath to prevent permanent staining. This is especially important in homes with
contamination from smoking, fireplaces, or where candles are burned.
• Ensurethefrontoftheunitfacesawayfromtheclosestwallorfurniture.
• Ensurenogrillesareblocked.
SET-UP
The True-HEPA Filter(s) are supplied within the air purifier. They are wrapped to
ensure purity, and are labeled to help identify the proper replacement filter
(Type
)
.
• Beforeusing your new air purifier you must remove the wrapper covering the
filter(s).MakesuretheairpurifierisOFFandunplugged.Whilepressingonthe
tab at the top of the rear grille, pull the grille towards you and remove it from the
unit and set it aside (See Fig. 2). Grasp the sides of each filter frame near its top
end and pull outward. Repeat for the second filter if applicable.
• Removeprotectivewrapfromthefilter(s).
• PlacetheHEPAfilter(s)intotheairpurifierhousingwiththearrowspointing
toward the unit. Insert the bottom edge of the filter frame and press the top of
the filter down and inward until the filter is firmly in place. Repeat for the second
filter if applicable.
Fig. 2
Install the Household Gas & Odour Reducing Pre-Filter that is supplied within the air purifier. It will be
wrapped in plastic wrap to keep it fresh (Type ).
• Removethepre-filterfromtheprotectiveplasticbag.
•Securethepre-filterunderthepre-filterclipsontheinsideofthereargrille.
• Replacethereargrillebyliningupthetabatthebottomofthegrillewiththeslotintheairpurifier.
Push the top of the grille towards the unit until it snaps in place. Snap the filter grille back into place.
INSTALL TRUE HEPA FILTERS AND ODOUR REDUCING PRE-FILTER

Other manuals for Honeywell HPA060 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell HPA060 Series and is the answer not in the manual?

Honeywell HPA060 Series Specifications

General IconGeneral
BrandHoneywell
ModelHPA060 Series
CategoryAir Cleaner
LanguageEnglish

Related product manuals