Controlling a PTZ Device | 47
800-16694 - A - 04/2014
Programming Presets
You can program up to 127 preset positions for the PTZ camera. For example, you can program
the camera to point at a specific location, such as a doorway, when an alarm event takes place.
To program a preset:
1. Go to Menu > Camera > PTZ > More Settings.
2. Use the direction buttons to point the camera at the location where you want to set the
preset.
3. Click Save Preset, and then click the number you want to assign to the preset. For
example, clicking "1" will save the preset as Preset 1, clicking "2" will save the preset as
Preset 2, and so on.
4. Repeat steps 2 and 3 to save more presets. You can click … to display additional
numbers.
To Next Page
Loading...
