Honeywell HRGX41 - Searching and Playing Back Video by Event

www.honeywell.com/security
72 | HRGX DVR User Manual
Searching and Playing Back Video by Event
You can search for and play back video recorded during alarm input and motion detection
events. Channel switch is supported. For information on configuring alarm input and motion
detection settings, see Configuring Alarms Inputs, page 84, and Configuring Motion Detection
Settings, page 89.
To search for and play back video by event:
1. Go to Menu > Clip Search > Event.
2. Under Event, configure the following search parameters:
3. Do one of the following:
•If Alarm Input was selected as the event type, select the alarm input(s) you want to
search from the list, or click Alarm Input No. to select all the alarm inputs.
•If Motion was selected as the event type, select the channel(s) you want to search
from the list, or click Analog to select all the channels.
•Event Type Select Alarm Input or Motion .
•Start Time Select the date and time for the start point of the search.
•End Time Select the date and time for the end point of the search.