Configuring HDD Settings | 115
800-16694 - A - 04/2014
Adding a Network HDD
To increase storage capacity you can add a connected NAS (Network-Attached Storage) device
or a SAN (Storage Area Network) device to the DVR as a network HDD. You can add up to 8
NAS devices or 7 NAS devices + 1 SAN device.
To add a network HDD:
1. Go to Menu > HDD > General.
2. Click Add to open the Add NetHDD window.
3. In the NetHDD list, select the NetHDD you want to add.
4. Set the Type to NAS or IP SAN.
5. In the NetHDD IP Address field, enter the IP address of the NAS or SAN device.
6. Do one of the following:
• For NAS, enter the directory of the NAS disk in the NetHDD Directory field
(for example, /dvr/9000).
To Next Page
Loading...
