Operation
Rev 3.01 90 Document 900.0258
10/05
Change Data Source
Figure 4-6 Change Data Source Screen
You can select the data source to be searched from:
• Local storage (Search On Local)
• Archive storage (Search On Archive)
To select the data source, highlight the desired source location and then press # .
Date/Time Search
Figure 4-7 Date/Time Search Screen
1. Move the cursor over the date and then press # .
You can use the Left and Right Arrow buttons to highlight the year, month and
day.
Use the Up and Down Arrow buttons to change to the date you want to search for
video. After you have set the date you want, press # .
2. Move the cursor over the time and then press # .
You can use the Left and Right Arrow buttons to highlight the hour, minutes and
seconds.
Use the Up and Down Arrow buttons to change to the time you want to search for
video. After you have entered the time you want, press # .
3. After you have set the date and time you want to search, highlight OK and then
press # . The selected date and time displays. (If no video was recorded at the
selected time, you will see a blank screen.)
4. You can now use the PLAY/PAUSE, RW, FF, Jog Dial, and Shuttle Ring controls
to review the surrounding video.
To Next Page
Loading...
