Installation
Rev 3.01 7 Document 900.0258
10/05
Connecting the Video Source
Figure 2-3 Video Input Connectors
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Connecting the Loop Through Video
Figure 2-4 Video Loop Through Connectors
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
Note The Loop BNC connectors are auto terminated. Do not connect
a cable to the Loop BNC unless it is connected to another
terminated device because it will cause poor quality video.
To Next Page
Loading...
