Honeywell HRHD4+ - Figure 3-24 Alarm out Schedule Screen

Configuration
Rev 3.01 42 Document 900.0258
10/05
Figure 3-24 Alarm Out Schedule Screen
2. To open a schedule screen, highlight the Sched field and then press # . You can
schedule alarm output in 30-minute increments from 0:00 to 24:00.
You can select individual blocks of time, entire days of the week, entire blocks of
time, or the entire schedule.
• Select a specific block of time by highlighting it.
• Select an entire day by highlighting the day of the week or Holiday on the left
of the screen.
• Select an entire block of time by highlighting the time at the top of the screen.
• Select the entire screen by highlighting the empty box in the upper left corner
of the screen. Press # from No Arming (no block) to On (blue block) to
Event (yellow block).
On means the Alarm Out is active during the scheduled time.
Event indicates the Alarm Out is only active when there is an Event during the
scheduled time.