Configuration
Rev 3.01 34 Document 900.0258
10/05
Note When the device is an IDE hard disk drive, you can change its
usage to either Rec. On or Rec. Off.
When the device is a SCSI hard disk drive, you can change its
usage to either Extension or Archive.
Caution A “–” displays when connecting a hard disk drive that was
previously used for something else. In this situation, device usage
can be changed as desired usages; for example, Extension to
Archive or Archive to Extension. However, changing the device
usage causes the stored data on the device to be lost.
The DVR can be set to react to storage problems by activating an internal buzzer or
external alarms, and/or notifying a remote site. Highlight the box beside Storage
Problem Action: Alarm Out/Notify and then press # to select from Beep, the alarm
output terminal that you want to associate with the storage problem event, and/or
Notify.
Highlight S.M.A.R.T. Setup and then press # . The S.M.A.R.T. Setup screen displays.
Figure 3-14 S.M.A.R.T. Setup Screen
Your DVR shows the condition of the hard disk drives if the installed IDE hard disk drives
support the S.M.A.R.T. program. Highlight the box beside Use and then press # to
toggle between On and Off.
The Last-check field displays the date and time information of the last storage check.
1. Highlight the box beside Period and select from Daily, Weekly, or Monthly for
the check interval.
To Next Page
Loading...
