Honeywell HRHD9+ - Alarm Out Setup Screen

Configuration
Rev 3.01 41 Document 900.0258
10/05
The menu choices are described as follows:
Alarm Out Setup Screen
Use the Alarm Out setup screen to establish a schedule for each alarm output from the
DVR. Highlight Alarm Out from the Device menu (MENU
➤ Device ➤ Alarm-Out) and
then press # . The Alarm Out Setup screen displays.
Figure 3-23 Alarm Out Setup Screen
1. To give each alarm output its own title, highlight the box under the Title heading
and then press # . A virtual keyboard displays (see Figure 3-7) allowing you to
enter the title.
Table 3-3 Motion Detection Zone Choices
Menu choice Description
Close this menu Closes the menu so that you can see the entire screen.
Select Current Blocks Activates highlighted blocks to detect motion.
Clear Current Blocks Deactivates highlighted blocks so that they will not detect
motion.
Select All Blocks Activates all blocks to detect motion.
Clear All Blocks Deactivates all blocks so that they will not detect motion.
Reverse All Blocks Activates inactive blocks and deactivates active blocks.
Exit Zone Setup Asks you to confirm changes and then returns to the previous
screen.