Honeywell HRHD9+ - Motion Detector Event Action (Notify) Setup Screen

Configuration
Rev 3.01 55 Document 900.0258
10/05
Motion Detector Event Action (Notify) Setup Screen
Use this screen to set the DVR to notify the remote site when certain motion events are
activated.
Figure 3-36 Motion Detector Event Action (Notify) Setup Screen
1. Highlight the Sched box and then press # . A schedule screen displays. Set the
schedule as described earlier.
2. Highlight the Notify box and then press # . This toggles between On and Off.
When it is On, the DVR notifies the remote site when certain events occur based
on a defined schedule.
Note For the Notify action to work, the DVR should be registered in the
RAS (Remote Administration System).