Honeywell HRHD9+ - Figure 3-58 USB Device Selection Screen; Figure 3-59 Disk Partition Selection Screen

Configuration
Rev 3.01 78 Document 900.0258
10/05
When more than two USB hard disk drives are installed on the DVR, the following USB
Device Selection screen displays.
1. Select the drive to use for clip copy and then press # .
2. Select Return to Clip Copy Menu and press # to exit the screen and return to the
Clip Copy screen without saving the changes.
Figure 3-58 USB Device Selection Screen
When the selected drive has more than two partitions, the following Disk Partition
Selection screen displays. If the file system is not FAT16 or FAT32, the Type displays
Not Supported.
Figure 3-59 Disk Partition Selection Screen
After you select the drive and partition to use for clip copy, the DVR displays the drive
capacity and the clip size, and asks if you want to continue.
Note Do not copy clips larger than 2 GB.
You can use other functions on the DVR while video is being copied. To do this,
highlight Close and then press # . You can return to the Clip Copy screen at any time
to check the progress.