www.honeywell.com/security
116 | Performance Series HQA Digital Video Recorder User Guide
Configuring Net Settings
You can configure the network settings with or without the ATM/POS protocol.
To configure the network settings with the ATM/POS protocol
1. Go to Main Menu > Setting > System > Card Overlay > Net.
2. On the Net tab, configure the following settings:
3. Click Apply, and then click Save to save the settings.
•Protocol Select ATM/POS.
•Overlay Mode
The
Preview
and
Encode
overlay modes are enabled by default.
Clear the check boxes if you want to disable them.
•Overlay Position
Select
Top Left
,
Bottom Left
,
Top Right
, or
Bottom Right
.
• Source IP/Port
Enter the source IP and port. The source IP refers to the host IP
address that sends out the information.
• Destination/Port
Enter the destination IP and port. The destination IP refers to the IP
address of the device that receives the information.
•Record Channel
Select a camera.
•Frame ID
Configure up to 6 Frame IDs to ensure valid and legal information.
Enter the
StartPosition
,
Length
, and
Key
. Click
Data
to enter
Start Position
,
Length
, and
Title
information for up to four fields,
and then click
Save
.
To Next Page
Loading...