Honeywell HRHM1041 - Remote Control Operation

Introduction | 19
800-19403 - A - 12/2014
Remote Control Operation
It is strongly recommended to use a mouse to operate the DVR. However, you can also use the
supplied IR remote control.The following table describes basic remote control operations:
Button Action
1Power Turn DVR on/off.
2 Add (Address) Enter number of device that you want to control.
3 Forward Increase forward playback speed.
4 Slow Play Decrease forward playback speed.
5 Next Record Select next video for playback.
6 Previous Record Select previous video for playback.
7 Play/Pause Pause/resume forward playback.
In live view mode, enter video search mode.
8 Reverse/Pause Pause/resume reverse playback.
9 Esc Return to previous menu or cancel current operation.
10 Rec Manually start/stop recording.
While in recording interface, use direction buttons to select
recording channel. Press and hold record button to enter
manual recording interface.
11 Direction Keys Use left/right keys to switch currently activated control.
While in playback mode, use up/down buttons to change
playback channel.
12 Enter Go to default. Go to menu.
13 Mult Switch between multi-channel view and single-channel view.
14 Fn In single-monitor mode, using popup assistant function,
control PTZ cameras or adjust video color.
In PTZ control mode, switch the PTZ control menu.
In text mode, press and hold button to delete last character.
15 Alphanumeric
Keys
Enter passwords or switch channels. Press
Shift to switch
input method.