www.honeywell.com/security
68 | Performance Series HQA Digital Video Recorder User Guide
Configuring TCP/IP and Port Settings
To configure TCP/IP settings
1. Go to Main Menu > Setting > Network > TCP/IP.
2. On the TCP/IP page, in the IP Version box, select IPv4 or IPv6, depending on the Internet
protocol that you want to use.
3. Set the Mode to Static or DHCP. Click Static to assign the DVR a static IP address or click
DHCP to assign it a dynamic IP address.
4. If Mode is set to Static, manually enter the IP Address, Subnet Mask, and Gateway
information. (The IP address, subnet mask, and gateway are not configurable when Mode
is set to DHCP).
5. If you want, enter Preferred DNS and Alternate DNS addresses.
6. To enable faster downloading over the local area network (LAN), select the LAN
Download check box.
7. Click Apply to save your settings.
8. If you want to exit the Setting menu, click Save.
To Next Page
Loading...