www.honeywell.com/security
72 | Performance Series HQA Digital Video Recorder User Guide
Configuring Advanced Network Settings
This section describes how to configure PPPoE, DDNS, SMTP, FTP, UPnP, SNMP, and
multicast settings.
Configuring PPPoE Settings
To enable a Point-to-Point Protocol over Ethernet (PPPoE) network connection
1. Go to Main Menu > Setting > Network > PPPOE.
2. On the PPPOE page, select the Enable check box to enable a PPPoE network
connection.
3. In the User Name and Password boxes, enter the user name and password provided by
your Internet service provider for PPPoE access.
4. Click Apply, and then click OK.
5. Restart the DVR for the new network connection settings to take effect.
The DVR’s new IP address appears on the PPPOE page. Use this address when
accessing the DVR remotely.
To Next Page
Loading...