Configuring Network Settings | 79
800-19403 - A - 12/2014
Configuring Multicast Settings
Multicast allows for simultaneous real-time monitoring of live video from the DVR at multiple
remote locations over the network.
To configure multicast settings
1. Go to Main Menu > Setting > Network > Multicast.
2. On the Multicast page, select the Enable check box to enable multicast.
3. In the IP Address box, enter a multicast IP address. The address must be valid for
multicasting and should be in the range 224.0.0.0 to 239.255.255.255 for IPv4 or have the
prefix ff00::/8. An address in the range 239.252.0.0 to 239.255.255.255 is recommended.
4. In the Port box, enter a multicast port number or use the default setting (36666).
5. Click Apply to save your settings.
6. If you want to exit the Setting menu, click OK.
To Next Page
Loading...