Performance Series HQA Digital Video Recorder Local User Guide
122
Configuring Zero-Channel Settings
The zero channel function lets you view several video sources on one channel in a web browser,
saving bandwidth and improving upload speeds.
To configure zero channel encoding
1. Go to Main Menu Setting System Display Zero-Channel.
Figure 12-7
2. On the Zero-Ch Encode tab, configure the following settings:
• Enable Select the check box to enable the zero-channel
function or clear the check box to disable it.
• Compression Select the desired video compression standard
from the list. The default setting is H.264.
• Resolution Select the desired video resolution from the list. The
default setting is D1.
• Frame Rate (FPS) Select a value between 1 and 30 (NTSC) or
between 1 and 25 (PAL).
• Bit Rate (Kb/S) Select a value between 896 and 4096. The default
setting is 1024.
3. Click Apply to save your settings.
4. Open a web browser, enter the DVR’s remote access IP address in the browser’s address
field, and then log in.
5. Select Multi-Preview in the remote web client interface to display all of the DVR’s video
sources in one channel.
To Next Page
Loading...
