Honeywell HRHT4041 - Configuring Pppoe Settings; Configuring DDNS Settings

Performance Series HQA Digital Video Recorder Local User Guide
76
Configuring PPPoE Settings
To enable a Point-to-Point Protocol over Ethernet (PPPoE) network connection
1. Go to Main Menu  Setting  Network  PPPOE.
Figure 9-5
2. On the PPPOE page, select the Enable check box to enable a PPPoE network connection.
3. In the User Name and Password boxes, enter the user name and password provided by
your Internet service provider for PPPoE access.
4. Click Apply, and then click OK.
5. Restart the DVR for the new network connection settings to take effect. The DVR’s new IP
address appears on the PPPOE page. Use this address when accessing the DVR remotely.
Configuring DDNS Settings
To enable a Dynamic DNS (DDNS) network connection
1. Go to Main Menu  Setting  Network  DDNS.