Performance Series HQA Digital Video Recorder Local User Guide
78
Configuring Sync Time
This function allows specified IP host to change device time in case several hosts are syncing
time with the device.
1. Go to Main menu->Setting->Network->Sync time.
2. Enter Sync time interface. See Figure 9-7.
3. Check the Enable box to enable Sync time function.
Figure 9-7
4. Click Apply or Save to complete setup.
Note
If the DVR has enabled NTP service, the device will sync time with the NTP server
regularly. The sync or change time operation of the IP address in the whitelist will
be invalid, unless the NTP server and the IP address in the whitelist is the same.
Configuring Email Settings
To configure email notifications
1. Go to Main Menu Setting Network Email.
To Next Page
Loading...
