Honeywell HRHT41612 - Configuring Tampering Settings

Performance Series HQA Digital Video Recorder Local User Guide
90
1. Go to Main Menu  Setting  Event  Video Detect  Video Loss.
Figure 10-6
2. On the Video Loss tab, in the Channel box, select the channel (camera) that you want to
configure video loss detection settings for.
3. Select the Enable check box to enable video loss detection for the selected channel.
4. To set the periods when video loss detection is active, next to Period, click Set, and then
follow the steps listed in To set up motion detection periods on page 86.
5. To set the actions that you want the system to initiate when a video loss event occurs,
follow the steps listed in To set up motion detection event actions on page 88.
6. Click Apply to save your settings.
7. To copy the settings to additional channels, click Copy, select the channels that you want
to copy the settings to, and then click OK.
Configuring Tampering Settings
To configure video tampering settings
1. Go to Main Menu  Setting  Event  Video Detect  Tampering.