Honeywell HRHT41612 - Face Detection Configuration

Configuring Network Settings
81
Configuring SNMP Settings
You can use Simple Network Management Protocol (SNMP) to receive information from the
DVR remotely. You will need to install SNMP software on a PC to receive information from the
DVR via SNMP.
To configure SNMP settings
1. Go to Main Menu  Setting  Network  SNMP.
Figure 9-10
2. On the SNMP page, select the Enable check box to enable SNMP.
3. Configure the following settings:
• Version Select the check boxes of the SNMP version(s) that
you are using.
• SNMP Port The default setting is 161.
• Read Community The default setting is public.
• Write Community The default setting is private.
• Trap Address Enter the IP address of the computer running
SNMP software.
• Trap Port The default setting is 162.
4. If SNMP Version V3 is selected, the following settings are also configurable:
ReadOnly User: The default setting is public.
Read/Write User: The default setting is private.
Authorize Type: Select the authorization type, MD5 or SHA, for both the
ReadOnly and Read/Write users. The default setting is MD5.