Honeywell HRHT41612 - 10. Configuring Event Settings; Configuring Motion Detection Settings

Configuring Event Settings
85
10. Configuring Event Settings
This chapter contains the following sections:
• Configuring Motion Detection Settings, page 85
• Configuring Video Loss Settings, page 89
• Configuring Tampering Settings, page 90
• Configuring Diagnosis Settings, page 91
• Configuring Face Detection Settings, page 93
• Configuring Alarms, page 95
• Configuring Abnormality Settings, page 97
• Configuring Temperature and Humidity Camera （ IOT ） , page 101
Configuring Motion Detection Settings
To set up motion detection regions
1. Go to Main Menu  Setting  Event  Video Detect  Motion Detect.
Figure 10-1
2. On the Motion Detect tab, in the Channel box, select the channel (camera) that you want
to configure motion detection settings for.
3. Select the Enable check box to enable motion detection for the selected channel.