Configuration | 69
800-22740 - A - 02-2017
Configuring Video Loss Detection Settings
You can configure the system to generate a video loss alarm when the minimum amount of
video loss (as defined by you) is detected in the video.
Note Video loss does not support anti-dither, sensitivity, or region setup.
Click Video Loss in the Event configuration interface to open the Video Loss configuration
interface.
Figure 3-38 Video Loss Configuration Interface
The configuration for Video Loss Detection is very similar to the configuration for Motion
Detection. Please see Configuring for Motion Detection on page 64 for more information.
Configuring Tamper Detection Settings
You can configure the system to generate a camera tampering alarm when the minimum
amount of tampering (as defined by you) is detected in the video.
Click Camera Tampering in the Event configuration interface to open the Camera Tampering
configuration interface.
Message Enable to send a message to the device which supported the
3G/4G module when the event triggers.
Log
Click to enable the DVR to record a local alarm log.
Alarm Upload Enable to allow Web Client to receive the alarm information
when triggered by an event.
Table 3-14 WEB - Motion Detection Configurations
Configuration Description
To Next Page
Loading...
