Honeywell HRHT4164 - Configuring Video Loss Settings

Configuring Event Settings
89
client).
• Send Email Select the check box to enable the system to
send an email notification. If the Snapshot
function is enabled, an image can be
attached to the email.
• Record Channel Select the channel(s) that you want to record.
In the Delay box, specify the amount of time
(1–300 s) to delay recording after a motion
detection event is triggered.
Note You also need to set the motion detection recording period. Go to Storage >
Schedule to configure the current channel for scheduled recording. See Configuring the
Video Recording Schedule on page 39.
• PTZ Activation Select the check box to activate PTZ functions,
and then click Select. In the PTZ Activation
window, for each PTZ camera, select the preset,
tour, or pattern that you want to be called when
a motion detection event occurs, and then click
OK.
• Delay (Latch) Set a length of time for the DVR to delay turning
off events and activated input after an external
alarm is cancelled.
• Tour Select the check box to enable a tour of the
selected channels.
• Snapshot Select the check box to take a snaphot of
selected channels.
• Video Matrix Click to enable. When an event occurs, the SPOT
OUT port video (a 1-window tour) from the event
activation channel selected in the Record
Channel.
• Buzzer Select the check box to activate a buzzer noise
at the DVR.
• Log Click to enable the DVR to record a local event
log.
• Voice Prompts Select to enable audio broadcast/voice prompts
in response to a motion detection event.
• File Name Select a file for the voice prompt.
3. Click Apply to save your settings.
4. To test your settings, click Test.
5. To copy the motion detection settings to additional channels, click Copy, select the
channels that you want to copy the settings to, and then click OK.
Configuring Video Loss Settings
To configure video loss settings