System Operation and Configuration
40
Figure 5-23 Properties
“S.M.A.R.T.Evaluation” has two indexes: “Pass”/Failed”; “Whole Evaluation” has three
indexes: “Good”/ “Normal”/ “Poor”. If “Whole Evaluation” displays “Poor”, user should replace
the disk to avoid the data loss.
Click OK to close the window.
PTZ Control
PTZ function is only available for cameras equipped with PTZ device.
To enable PTZ function:
1. Select a camera in the “Device” list and click the
icon in the bottom right corner. In
the popped up “Edit Camera” window, click “Advanced Settings”. In the “Advanced
Settings” window, enable the “PTZ” option. After clicking OK, the icon of the target
camera is changed to
.
2. Drag the target camera icon from the “Device” list to the video window.
3. Move the cursor to the bottom of the current video window and the hidden PTZ control
bar is displayed as shown in the following figure:
Figure 5-24 PTZ Control Bar
Click
to display the control interface as shown in the following figure:
To Next Page
Loading...
