Honeywell
61
Figure 5-63 System Settings
6. Set Pre-Recording and Post-Recording: Pre-Recording—starts recording a few
seconds before triggered alarms; Post-Recording—continues recording a few seconds
after the alarm event occurs.
Click Save Profile in Figure 5-63. The new profile is displayed in the “Alarm Profile” list as
shown in the following figure:
Figure 5-64 Alarm Profile List
Edit
To edit a profile, select that row and click Edit in “Alarm Profile” list (Figure 5-64), refer to
“New Profile” operation.
Remove
To remove a profile, select it and click Remove in “Alarm Profile” list (Figure 5-64).
System Setup
This section describes the settings and related operations.
General Settings
Navigate to System SetupGeneral Settings and the below figure is displayed:
To Next Page
Loading...
